Welcome: Dongguan Jiezheng Mold Products Co.,LTD.
Language: Chinese ∷  English

Industry new

Design Essentials of Putter in Design of Plastic Mold

Today is Sunday, in general, Dongguan Plastic mold factory is a holiday, but there are individual factories are now in the season, still non-stop work, the editor I was one of them, today to introduce the design of the plastic mold putter design points The


Putter should be located in the launch of the most resistance to the place, should be noted that the core and (or insert) too close, so as not to affect the punch or die strength.


When the plastic parts around the introduction of the same resistance, the putter should be a balanced arrangement, so that when the plastic parts were launched evenly to prevent deformation.


When the plastic parts have local bosses or ribs, the push rod is usually located at the bottom of the boss or rib.


Putter should not be located in the plastic parts of the thin wall, if the structure needs, can increase the area to improve the plastic parts of the force situation.


When the plastic parts are not allowed to launch traces, you can use the introduction of ear form. Putter should be located in the launch of the most resistance to the place, should be noted that the core and (or insert) too close, so as not to affect the punch or die strength.


Putter should be located in the launch of the most resistance to the place, should be noted that the core and (or insert) too close, so as not to affect the punch or die strength.


When the plastic parts are not allowed to launch traces, you can use the introduction of ear form.


Put rod diameter should not be too small, should have sufficient strength, stiffness to withstand the launch force.


Usually put rod diameter to take 2.5 to 12 mm, the diameter of less than 3 mm slender putter should be made of the lower side of the stepped shape.




Note: The above information from the Jiezheng  mold on the Internet, welcome reproduced, indicate the source!

CATEGORIES

CONTACT US

Contact: Mr. Zhang

Phone: 13509005172

Tel: 0769-85394568

Email: jiezhen_tech@163.com

Add: Dongguan Changan Licheng Industrial F building

Website:www.128jz.com

    www.moldjz.com

Scan the qr codeClose
the qr code